Search Results

  1. When should I replace the catappa leaves? Most leaves last about one to two months until they break down completely. Once you start seeing holes develop in the first leaf, add a second leaf to give it time to start breaking down and releasing tannins. For more details on the benefits of catappa leaves, read our full article.
  2. Do I need a power head? A powerhead is simply a submersible water pump that sucks in water from the input and sprays out a powerful stream of water from the output. This device can be used to speed up water changes, create your own DIY filtration, and of course boost water circulation in your aquarium. Water circulation is commonly discussed in the saltwater aquarium hobby in order to imitate the movement of waves, but not having enough flow can also be a problem in freshwater setups. Fish tanks (especially large on...
  3. Where should I place my powerheads? Locate the dead spots in your aquarium by observing where debris is collecting the most or if blue-green algae is growing in certain areas. Using a power head can help disperse the decaying organics in those stagnant regions so that they get sucked up by the filter, thus making your water clearer overall. If your heater has a “low flow” indicator that constantly goes off, consider putting the power head near it so that the heated water can spread throughout the rest of the fish tank and elimi...
  4. Can a power head be used as a filter? Yes, power heads can be used as part of your filtration system. Many people use them to transfer water from their aquarium sump filter (which is a type of custom filtration) back into the fish tank. We also designed our powerhead pump to fit perfectly with the Aquarium Co-Op sponge filters. Normally, an air pump is used to run a sponge filter and gently draw water through the foam material. By attaching a power head to the sponge filter instead, water is pulled through the foam at higher spee...
  5. How big of a power head do I need? Some websites say that water should circulate around a tank at least four times an hour, so if you have a 100-gallon tank, then you need a filter and/or powerhead that can move 400 gallons per hour (GPH). In our experience, the ideal flow rate depends on the plants and animals in your aquarium because some species can’t handle strong current and may become sick from all the stress. If you see that your fish and foliage are being whipped around the tank, choose a less powerful filter or power ...
  6. What are Indian almond leaves used for? When you drop a dried catappa leaf into your aquarium water, the leaf begins to slowly decompose and produce tannins, which are plant-based compounds that gradually lower the pH and stain the water with a yellow-brown tint. Benefits include: Lower pH and softer water for keeping and breeding lower pH species Antibacterial and antifungal properties for healing mild ailments Food for baby fish and shrimp Tinted water for creating a blackwater aquarium or biotope For more details on whether or...
  7. What are power heads? For larger aquariums or fish tanks that need faster flow, a power head is great option because of its versatility in multiple applications. A powerhead is simply a submersible water pump that sucks in water from the input and sprays out a powerful stream of water from the output. This device can be used to speed up water changes, create your own DIY filtration, and of course boost water circulation in your aquarium. For more information, read our full article on water circulation.
  8. Do I need carbon in my aquarium filter? Because activated carbon (and most chemical filtration) is disposable and cannot be reused, we like to save it for specific instances when we know there are pollutants or tannins that we wish to remove. If you are preparing for an aquarium photoshoot, you may choose to use carbon to ensure the water is extremely clear. However, most hobbyists do not use carbon on a daily basis because it gets depleted so quickly and the results may be temporary. For more information on filter media, read the ...
  9. What’s the difference between a powerhead and a wave maker? A fish tank powerhead typically shoots a narrow jet of water in one direction, whereas a wave maker is meant to imitate the back-and-forth motion of ocean waves. For more information, read our full article on water circulation.
  10. How many watts does a powerhead use? Each model is different, but the Aquarium Co-Op power head uses 10 W of power to produce 211 GPH or 800 liters per hour (LPH). For more information, read our full article on water circulation.
  11. What order should I put the aquarium filter media? There are many ways to layer the filter media in your filter, so these are our general suggestions. The first step is to look in the manual and find out which direction the water flows through the filter. As the water enters the filter media basket, we like to use a coarse sponge pad as mechanical filtration to block the largest chunks of debris and prevent them from entering the rest of the filter media. If you need to use the ammonia or phosphate media pads, you can place them here since th...
  12. What is hydra and how do I get rid of it? These tiny, freshwater organisms of the genus Hydra are the distant relatives of jellyfish, corals, and sea anemones. Growing up to 0.4 inches (1 cm), they range in color from translucent white to green to light brown. Much like a sea anemone, hydra has a stalk or foot that attaches to surfaces (like plants, hardscape, or glass) and a mouth at the other end that is surrounded by long, wispy tentacles. These tentacles have stinging cells that are used to paralyze and catch their prey. Scientis...
  13. How long does aquarium filter media last? Reusable filter media – such as the coarse sponge pad, bio rings, and Purigen – can last for many years, as long as it can be cleaned sufficiently so that its functionality is not impaired. Fine poly pads should be disposed when they turn brown in color and water cannot move through them as easily. A general rule of thumb is to change chemical filtration (like activated carbon, ammonia media pads, and phosphate pads) once a month, but the only surefire way to tell if they are spent is to meas...
  14. How do I clean an aquarium filter without killing bacteria? Remove the filter media and rinse them in old aquarium water or dechlorinated water to remove any accumulated waste. Coarse sponge pads are the dirtiest and can be vigorously wrung to clean it as much as possible. Bio media houses beneficial bacteria and should be gently agitated (not scrubbed) in the water. Chemical filtration needs to be replaced entirely when used up (unless you’re using Purigen, which can be cleaned with diluted bleach). The frequency of filter maintenance depends on many...
  15. How do I get rid of algae in my fish tank? Algae is a natural part of the aquarium ecosystem because it helps to purify the water from toxic waste chemicals and serves as a food source for algae-eating fish and invertebrates. However, most people see it as an unwelcome guest since too much algae can obstruct your view of the fish tank and slow down healthy plant growth. Let’s talk about 5 easy methods for cleaning algae off your aquarium walls and decorations. Use tools to manually remove algae Get help from algae eaters Remove exces...
  16. How did hydra get in my fish tank? In our experience, we’ve noticed that hydra often lays dormant in fish tanks for many months, but then the population blooms when you start heavily feeding baby brine shrimp. It’s possible that the hydra hitchhiked from aquarium decorations, aquatic plants, rocks, or driftwood that came from an infected tank. Hydra can also be introduced if you collect live foods, plants, or hardscape from the wild. For more information, read our full article on How to Get Rid of Hydra in Your Aquarium.